usomiq-pins
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
usomiq-pins [2013/09/09 04:03] maxx [Table 1. Pins on the P2 connector] |
usomiq-pins [2014/10/01 02:03] (current) maxx [uSomIQ mainboard connectors pins] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== uSomIQ mainboard connectors pins ====== | ====== uSomIQ mainboard connectors pins ====== | ||
| + | This the description of signals arranged on the uSomIQ side and its connectors P2 and P3. A baseboard connectors will have the same signals but with different numbering. For instance, pin1 of P2 on the module connects to pin2 of the baseboard connector, pin2 of P2 on the module connects to pin4 of the baseboard connector etc. | ||
| ===== Table 1. Pins on the P2 connector ===== | ===== Table 1. Pins on the P2 connector ===== | ||
| Line 32: | Line 32: | ||
| | 27 | MCASP0_ACLKX | | | 27 | MCASP0_ACLKX | | ||
| | 28 | ANALOG GND | | | 28 | ANALOG GND | | ||
| - | | 29 | nc | | + | | 29 | BAT_IN | |
| | 30 | UART0 RX | | | 30 | UART0 RX | | ||
| - | | 31 | nc | | + | | 31 | BAT_SENSE | |
| | 32 | UART0 TX | | | 32 | UART0 TX | | ||
| - | | 33 | nc | | + | | 33 | BAT_TS | |
| | 34 | UART1 RTS | | | 34 | UART1 RTS | | ||
| | 35 | SYS_RESETN | | | 35 | SYS_RESETN | | ||
usomiq-pins.1378713833.txt.gz ยท Last modified: 2013/09/09 04:03 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
