MENTOREL Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== uSomIQ mainboard connectors pins ======

Table 1. Pins on the P2 connector
^ Pin # ^ Function ^
| 1 | 5VDC |
| 2 | GND |
| 3 | 5VDC |
| 4 | GND |
| 5 | 3VDC OUT |
| 6 | 1.8VDC OUT |
| 7 | 3VDC OUT |
| 8 | PWR Button to TPS65217 |
| 9 | I2C0 SDA |
| 10 | ANALOG GND |
| 11 | I2C0 SCL |
| 12 | ADC IN0 |
| 13 | MCASP0_AXR1 |
| 14 | ADC IN1 |
| 15 | MCASP0_ FSR |
| 16 | ADC IN2 |
| 17 | MCASP0_ACLKR |
| 18 | ADC IN3 |
| 19 | MCASP0_AHCLKR |
| 20 | ADC IN4 |
| 21 | MCASP0_AXR0 |
| 22 | ADC IN5 |
| 23 | MCASP0_FSX |
| 24 | ADC IN6 |
| 25 | MCASP0_AHCLKX |
| 26 | ADC IN7 |
| 27 | MCASP0_ACLKX |
| 28 | ANALOG GND |
| 29 | nc |
| 30 | UART0 RX |
| 31 | nc |
| 32 | UART0 TX |
| 33 | nc |
| 34 | UART1 RTS |
| 35 | SYS_RESETN |
| 36 | UART1 CTS |
| 37 | GPIO0_20 |
| 38 | UART1 RX |
| 39 | GPIO0_19 |
| 40 | UART1 TX |
| 41 | GND |
| 42 | UART3 RX |
| 43 | DCAN1 RX |
| 44 | UART3 TX |
| 45 | DCAN1 TX |
| 46 | SPI0_D1 |
| 47 | MMC0 DATA3 |
| 48 | SPI0_D2 |
| 49 | MMC0 DATA2 |
| 50 | SPI0 SCLK |
| 51 | MMC0 DATA1 |
| 52 | SPI0 CS0 |
| 53 | MMC0 DATA0 |
| 54 | USB0 VBUS |
| 55 | MMC0 CMD |
| 56 | USB0 DRVBUS |
| 57 | MMC0 CLKO |
| 58 | USB0 ID |
| 59 | GND |
| 60 | GND |
| 61 | ETH RX+ |
| 62 | USB0+ |
| 63 | ETH RX- |
| 64 | USB0- |
| 65 | GND |
| 66 | GND |
| 67 | ETH TX+ |
| 68 | ETH SPEED 100 LED |
| 69 | ETH RX- |
| 70 | ETH ACTIVE LED |

MENTOREL Wiki

User Tools

Site Tools

Page Tools