This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
somiq-pins [2013/03/13 00:33] admin77 [X3 signals] |
somiq-pins [2013/03/13 00:41] (current) admin77 |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | All SomIQ modules have almost identical set of signals on sockets, except for signals/interfaces absent on used processors. | ||
+ | |||
+ | **NOTE:** | ||
+ | * SomIQ-AM35 lines have IO voltage **3.3V** | ||
+ | * SomIQ-AM37 lines have IO voltage **1.8V** | ||
+ | |||
+ | Use voltage translators powered by VCC_IO on the CPU side | ||
+ | |||
====== X2 signals ====== | ====== X2 signals ====== | ||
Line 140: | Line 148: | ||
| 33 | UART2_RTS ^ NC ^ NC | UART2 RTS | | | 33 | UART2_RTS ^ NC ^ NC | UART2 RTS | | ||
| 34 | GPIO_30 ^ NC ^ NC | GPIO_30 | | | 34 | GPIO_30 ^ NC ^ NC | GPIO_30 | | ||
- | | 35 | NC | NC | NC | Не используется | | + | | 35 | NC | NC | NC | no connection | |
| 36 | nRESET | nRESET | nRESET | CPU reset | | | 36 | nRESET | nRESET | nRESET | CPU reset | | ||
| 37 | VCC_IO | VCC_IO | VCC_IO | IO Voltage output | | | 37 | VCC_IO | VCC_IO | VCC_IO | IO Voltage output | |